Ford Racing 65mm Cobra Jet Billet Aluminum Throttle Body (frpM-9926-CJ65)

DESCRIPTION

Ford Racing Hi-Flow throttle bodies provide more air and power than stock throttle bodies, while also providing good drivability and low-speed control. They are built with high-quality aluminum castings and accept all stock sensors and controls.

FEATURES

- Fits in factory location on 2007-2014 Mustang Shelby GT500
- Fits 2011-2014 Mustang GT with Ford Racing supercharger kit M-6066-MGT624D. (Calibration required)
- Fits 5.0L Cobra Jet Intake Manifold M-9424-M50CJB
- Dual 65mm bore (stock SVT Mustang is dual 60mm bore)
- CFM Rating: 1517cfm.*
- Precision machined from billet aluminum to ensure consistency
- Polished finish with CNC'd Ford Racing logo
- Fully assembled, complete with throttle position sensor and actuator motor, ready to bolt on!
- Uses OE gears to prevent gear bind and wear common with other aftermarket throttle bodies
- Does not include calibration, calibration required.

All Ford Racing ETC throttle bodies feature:
- All factory sensors installed - no need to tear apart your original throttle body
- Calibrated for idle air flow using the same procedure as production throttle bodies
- Precision billet construction with tapered inlet for consistent high flow
- Polished aluminum for great looks and underhood "bling"
- The only throttle bodies backed by Ford Racing with the logo CNC'd in
- Validation through hundreds of hours of dyno, racing, and street performance driving

*All cfm ratings are calibrated at 28-inches of water, measured on SuperFlow SF-1020 Flow Bench.

WARNING CA Proposition 65

No